C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

The I2C operation mode is I2C_OPER_MODE_POLLING, and SENSOR_I2C_TIMEOUT is 5000. When the camera's I2C communication is abnormal, it can sometimes cause the MCU2_0 OS to block for about 18 seconds.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Referring to the list of clock identifiers in the link and also refer the clock summary taken from /sys/kernel/debug/clk ...

Related to this older thread, I'm also trying to get uvc-gadget to work, on a J784S4XEVM this time. My script is listed below. #! /bin/sh GADGET_DIR="/sys/kernel ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

Between the available BringupGuides I selected the AFE7950+ TSW14J57.pptx During the first steps of the procedure, I understood that I had to download the HSDC Pro application. I downloaded the High ...

Have you scoped the data/clock line when sending the ACK to make sure there is an ACK there? Is there a reason you need to use the manual ACK rather than the default automatic ACK that is used in the ...

In continuation with my previous question asked in the forum, I have designed a 100ohm differential trace on a PCB instead of coax cable for FPD-Link III communication between UB953 and UB960. However ...