设置SPI多个片选引脚除了config里面定义的其余引脚是否需要用GPIO虚拟，同时虚拟出来的引脚对传输速率是否有影响 可以使用GPIO模拟，在每次SPI发送之前，对SPI的片选信号也会进行控制，所以SPI的片选信号就是在每次需要发送到某个设备的时候，将CS片选端进行 ...

To test the runtime of the modified iqmath function, I executed it in both TCMA and OCRAM. My environment is CCS12.8，SDK 10.0.0.37 code optimization O-fast To prevent caching of identical computation ...

Understanding these aspects is crucial for our project and system stability. Any insights or additional documentation you could provide would be highly valuable. Thank you for your assistance.

I think i have identified a discrepancy in the documentation of the MSTGENA field descriptions for the Memory Self-Test Controller Global Enable Key. This needs to be reviewed and corrected to align ...

i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

This is the test result. this is how we set carrier wave mode. a customer PCB but follow the EVM schematic and layout. Smart RF Studio 7 continuous TX mode is not carrier wave. Can I adjust FSCTRL and ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

Hi, in the TIDA-010210-GaN reference design, the isolation module U2 uses UCC14150DWNQ1, and this chip cannot be queried on TI's official website. Is it possible to completely replace UCC14150DWN with ...

I am trying to implement state machine based tasks in 28027. I referred some programmes given in control suite. I am however not able to go between various tasks A0, A1, A2 etc. What could be the ...

We have encountered a boot up issue with TDA4AL at -40 degree C. The boot up process hanged and cannot be recovered even we try to reset the PMIC power on process. The boot process kept the same ...

Hi I want to get an interrupt when a SPI reception finished. My setup is the following. I have an SPI D configured as master with loopback mode. My actual application will be configured as slave but ...

Good morning. I'm new to the forum. unfortunately I have the same communication problem mentioned above with the ADS1115 chip. I cannot read the registers of the ADS1115 chip, both in the config ...