If a place a Voltage Generator on a new schematic and then attempt to change the signal type (from the default Unit step) to any other type (e.g. sine wave) then Tina TI freezes and is unresponsive.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

I am using TPS546D24A in my design & below are the details. 1. I would like to calculate the power dissipation of this device. Is there any tool/excel available to calculate the Power dissipation of ...

Hello, I have a question regarding my DSP28377D board. It has been running normally for some time, but occasionally (it has happened many times, with a probability of about 1%) the program fails to ...

Our final code is built from several projects one of which is specific to the product. The others are general projects which are designed to run on any product. Each is built into an abs file, and the ...

I am using the TLV5636 12-bit DAC. I have noticed by single stepping through the debugger that the first DAC register write immediately following a Reference Select control register write is IGNORED.

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

I am making Phase shift full bridge converter by using TMS320F280039C. I am running the voltage controller in CLA as below. Voltage controller execution time is 3us. So running CLA at 300kHz. I want ...